- 1 LED bulb
|Colour Reproduction Index RA (min.)||80|
|Product Division||Home & Living|
|EAR Reg.No.||DE 38720470|
|Electrical Efficiency Factor of the Bulb (min.)||0.96|
|Energy Efficience Class||E|
|Lamp Lumen Maintenance Factor at 6000h||0.8|
|Mains Frequency||50 Hz|
|Nominal Beam Angle||330 °|
|Nominal Light Output||2000 lm|
|Nominal Power Consumption||15 W|
|Operating Voltage||230 V|
|Premature Failure Rate||0 %|
|Rated Beam Angle||330 °|
|Rated Light Output||2000 lm|
|Start-Up Time Until 95% of Full Light Output Has Been Reached (max.)||1 s|
|Weighted Energy Consumption||15 kWh/1000h|
|Can be Dimmed||Yes|
|Bauform / Durchmesser / Höhe||J / 29 mm / 118 mm|
|Lamp Survival Factor at 6000h (min.)||0.9|
|Light color / color temperature||Warm White - 2700 K|
|Light efficiency||133.33 lm/W|
|Nominal Service Life||25000 h|
|Number of LEDs||96|
|Number of Switching Cycles until Premature Failure (min.)||40000|
|Operating Position||360 °|
|Optimal Ambient Temperature||25 °C|
|Power Consumption of an Equivalent Incandescent Lamp||125 W|
|Starting Time (max.)||0.5 s|
|Type||LED Lamp 230V|
|Net Weight||93 gr|
|Lamp Current||69 mA|
|Lamp Lumen Factor at End of Nominal Service Life (min.)||0.700|
|Rated Power Consumption||15 W|
|Rated Service Life||25000 h|
|Recommendations for Recycling||Recycling Depot or Collection Point|
|Suitable for Accent Lighting||No - Beam Angle between 120° and 360° (Φuse)|
The LED light is designed for operation in open luminaires: the heat generated by the light during operation can therefore be emitted into the surroundings. The service life prognosis is based on this mode of operation. The service life is reduced by insufficient cooling when used in enclosed luminaires. Only use in lights intended for its use. Allow the light to cool down completely before changing it and switch off the power supply voltage. Damaged lights should be replaced immediately. No liability shall be assumed for damage caused by incorrect use.
Some dimmers can impair the function of the light (flickering, noise).
Mixed operation, i.e. the simultaneous operation of LED bulbs and standard incandescent bulbs or LED bulbs of different types on one dimmer cable, is not possible. If noises are heard with dimmers that were not noticed with incandescent bulbs: the dimmer is not suitable for LED bulbs.
Cable dimmers (dimmer integrated into the power cable) require a separate on/off switch since they may not be able to regulate right down to 0.
Note the dimmer's minimum load, otherwise it may not switch on or it may control the light incorrectly. Simple dimmers usually work from 60W to 400W.
With integrated dimmers that have a basic brightness setting, this must be set high enough otherwise the LED bulb may not switch on.
Dim slowly and evenly. Do not dim quickly or with jerky movements.
Only incandescent bulb dimmers are permitted - not dimmers for transformers, etc.
Touch dimmers are usually not suitable. Incorrect dimmers can permanently damage lighting.