LED Bulb, G13, 2160 lm Replaces 36 W, Tube Bulb T8, 120 cm, daylight, Glass

E Item Type : Lamps
8,39 EUR SRP
VAT included

More product information

  • LED tube as an energy-saving replacement for fluorescent tubes
  • Easy exchange of fluorescent tubes, which are operated in lamp housing using starters and a conventional AC-adapter (CLB and LLB)
  • No conversion of lights required - the supplied dummy starter must, however, be exchanged with the existing starter
  • Immediate start without flickering even at low temperatures down to -20°C
  • The brightness in the primary beam direction is almost identical to that of fluorescent tubes (except when the light is fitted with highly efficient specular louvres)
  • Long service life even when switched on frequently
  • Saves about 50% energy compared to conventional fluorescent tubes
Quality based on German standards
Quality based on German standards
From the initial sample to series maturity: our products undergo strict and comprehensive quality controls, managed and carried out in Germany. This enables us to guarantee compliance with all specifications, guidelines and standards – and satisfy the strictest demands.

What's in the Box

- 1 LED tube
- 1 dummy starter
- 1 instruction manual

Détails Techniques

Indice de rendu des couleurs 80
Température de couleur Lumière du jour
Angle de faisceau 200 °
Choix/réglage de la couleur lumineuse Non
Source de lumière connectée (CLS) Non
Rég. EAR N° DE 38720470
Consommation d'énergie en mode marche 18 kWh/1000h
Classe d'efficacité énergétique (A à G) E
Fréquence 50 Hz
Durée de vie L70B50 - LED et OLED 15000 h
Technologie d'éclairage utilisée Ampoule LED
Source lumineuse Non directionnel
Facteur de maintien du flux lumineux (LED/OLED) 93 %
Alimentation en mode marche (Pon) : 18 W
Effet stroboscopique pour LED et OLED MLS 1
Stabilité de la couleur 2 ≤
Flicker pour LED et OLED MLS 0 ≤
Indice de rendu des couleurs R9 14
Facteur de décalage pour Pon (min.) 0,868
Facteur de durée de vie (pour LED et OLED) 0,9
Flux lumineux utile (Φ360) 2160 lm
Température de couleur 6500 K
Design / Diameter / Height Röhrenlampe T 8 / 28 mm / 1200 mm
Classe IP IP20 (Pièces sèches)
Douille G 13
Position de fonctionnement 360 °
Température optimale 25 °C
Poids Net 172 g
Voltage 133 mA
Convient pour l'éclairage d'accentuation Non - demi-angle entre 120 ° et 360 ° (Φuse)

Note for Consumers

Only for private use and not for long-term commercial use
Only for use in individual switching (lights have their own starter for each fluorescent tube)
Not suitable for electronic ballasts (lights without starters)

CLB = Conventional Loss Ballast, the most widespread system
LLB = Low Loss Ballast
EB = Electronic Ballast

Any changes to the wiring should only be carried out by qualified electricians. Incorrect installation could result in injury or damage to property.
Before carrying out any conversion work, ensure that there is no voltage.
Any defects due to incorrect installation are not covered by the warranty.
In addition to the power consumption of the LED tubes, CLBs that have not been disconnected/bypassed in particular have a high and unnecessary power loss and can cause high voltage peaks. Voltage peaks reduce the service life of the tubes. The disconnection/bypass must only be carried out by a qualified electrician.
Power loss in LLBs is considerably lower and so disconnection/bypass is not so important.

If a light that has been converted to LED tubes is fitted with fluorescent tubes once again, a fluorescent tube starter will need to be refitted. Every light that has been converted to LED tubes should feature a warning notice next to the starter.

The overall efficiency and light distribution is determined not just by the characteristics of the LED tubes, but also by the construction and characteristics of the lights.

Téléchargements

Fiche produit

Téléchargement

Notices d’utilisation

multilingue
Téléchargement